Kiln Results 4/11
April 14, 2022
This has my first tries at using vinyl resist made from my Cricut. I did both a clear coat over the resist and bare clay. A few of them I did vinyl on the inside as well as the outside. It was actually really difficult to get the vinyl out from the inside without messing up the glaze. I had read not to try to use any lines that were too fine and I definitely think that's key. Also key is having something small and pointy to get under the vinyl. Definitely happy with how these turned out. It is a bummer that they end up only being able to be used one time vs a stencil that can be used multiple times, but for a curved surface I think it would be too difficult to keep the stencil in place. Definitely going to make some more.
Made some more lemon plates. Actually I made strawberry and grape plates too, but they didn't make it into this kiln. Once again they came out gorgeous and I'm over the moon for them.
Made some more lemon plates. Actually I made strawberry and grape plates too, but they didn't make it into this kiln. Once again they came out gorgeous and I'm over the moon for them.
0 comments